|
Jump-O-Bot
DAT File
Instructions
|
|
Unlike other biomorphic robots, Jump-O-Bot does not rely on fine tuning to perform well. If it's built following these instructions, it will work as long as the pieces stick together, which should be quite long despite the constant shaking. Make sure you press them tightly, but allow free spinning and pivoting of the caster wheel. For better performance, lift the robot off the floor before turning it on and use it on hard floors only. Have fun!
|
|
|
Step 1
1 x Plate 1 x 4 ( 3710 ) - Black |
|
Step 2
2 x Plate 1 x 4 ( 3710 ) - Black |
|
Step 3
1 x Plate 1 x 4 ( 3710 ) - Black |
|
Step 4
2 x Plate 1 x 3 ( 3623 ) - Black |
|
Step 5
1 x Electric Brick 2 x 2 x 2/3 with Wire End ( 5306 ) - Black |
|
Step 6
2 x Plate 1 x 2 ( 3023 ) - Light-Gray |
|
Step 7
1 x Electric 9V Battery Box Small ( 4760 & 4761 & 4762 ) - Black |
|
Step 8
2 x Plate 2 x 4 ( 3020 ) - Black |
|
Step 9
1 x Technic Axle 3 ( 4519 ) - Black |
| Top | |
| Do you like it? | LEGO®, LEGOLAND®, LEGO SYSTEM®, LEGO TECHNIC®, DUPLO®, LEGO PRIMO® and LEGO MINDSTORMS® are trademarks of the LEGO Company which does not sponsor, authorize or endorse this site. |